Hubbardton Forge 18820 - Manual

Assembly & Installation Instructions
A131
For Single Ellipse Pendants 18-820, 18-820F, 18-830 & 18-830F Page 1 of 3
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735 20807 Rev B
Please Note: Pendant 18-820 shown in illustrations.
Stem Assembly (Figure 1)
Component Parts
A Fixture Pipe
B Fixture Coupling
1. Carefully unpack the fixture from the carton.
2. Carefully thread fixture pipe (A), threaded end first, over fixture wires.
3. Apply a drop of the supplied thread locking compound to the internal threads of fixture
coupling (B) and screw stem into fixture, being careful not to twist or pinch the wires.
Note: Application of the thread locking compound is necessary to prevent the stem from
loosening during regular maintenance and cleaning of the fixture. Be certain to apply the
compound.
4. See instructions below to complete the installation.
Assemble Canopy ( Figure 2)
Component Parts
C Hex Nut
D Lock Washer
E Canopy
G Nipple
1. Insert nipple (G) in swivel up through hole in canopy (E).
2. Place lock washer (D) and nut (C) onto the nipple (G) in swivel and tighten
securely.
Note: If installing on a sloped ceiling, make certain that the notch in the swivel
portion of the stem is oriented toward the downward side of the slope.
(continued)
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL
INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.
This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
(Figure 1)
(Figure 2)