Hubbardton Forge 18793 - Manual

Assembly & Installation Instructions
A196
For Pendant 18-791 & 18-793 Page 1 of 5
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735 22609
Stem Assembly (Figures 1 & 2)
Component Parts
A 8-32 Screw (2)
B Top
Assembly
C Bottom Assembly
D Fixture Pipe
E Fixture Coupling
1. Carefully unpack the fixture from the carton.
2. Remove two 8-32 screws (A) from top assembly (B) to separate from bottom assembly (C). Place bottom assembly
(C) and two 8-32 screws (A) to the side for later use.
3. Carefully thread fixture pipe (D), threaded end first, over fixture wires.
4. Apply a drop of the supplied thread locking compound to the internal threads of the fixture coupling (E) and screw
stem into fixture, being careful not to twist the wires.
Note: Application of the thread locking compound is necessary to prevent the stem from loosening during regular
maintenance and cleaning of the fixture. Be certain to apply the compound.
5. See instructions below to complete the installation.
(continued)
(Figure 2)
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL
INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.
This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
(Figure 1)