Hubbardton Forge 18825 - Manual

Assembly & Installation Instructions
A226
For Single Ellipse Pendants 18-825 & 18-825F Page 1 of 3
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735 23909
Please Note: Pendant 18-820 shown in illustrations.
Stem Assembly (Figure 1)
Component Parts
A Fixture Pipe
B Fixture Coupling
1. Carefully unpack the fixture from the carton.
2. Carefully thread fixture pipe (A), threaded end first, over fixture wires.
3. Apply a drop of the supplied thread locking compound to the internal
threads of fixture coupling (B) and screw stem into fixture, being careful
not to twist or pinch the wires.
Note: Application of the thread locking compound is necessary to prevent
the stem from loosening during regular maintenance and cleaning of the
fixture. Be certain to apply the compound.
4. See instructions below to complete the installation.
Assemble Canopy ( Figure 2)
Component Parts
C Hex Nut
D Lock Washer
E Canopy
F Nipple
1. Insert nipple (F) in swivel up through hole in canopy (E).
2. Place lock washer (D) and nut (C) onto the nipple (G) in swivel and
tighten securely.
Note: If installing on a sloped ceiling, make certain that the notch in
the swivel portion of the stem is oriented toward the downward side of
the slope.
(continued)
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL
INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.
This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
(Figure 1)
(Figure 2)