Hubbardton Forge 18870 - Manual

H U B B A R D T O N F O R G E . C O M
hand-forged, vermont-made lighting and accessories
154 RT. 30 SOUTH • CASTLETON, VERMONT 05735
All designs and images ©1989-2013 Hubbardton Forge ® . All rights reserved. 30438
Assembly & Installation Instructions
If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased this product.
We hope you enjoy your fixture!
* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.
Note: After installation extra hardware and accessories are possible due
to our kits are used on multiple products and options.
To Complete Fixture Assembly (Figures 1 & 2)
Component Parts
A Fixture
B Fixture Pipe
C Canopy
D Crossbar
E Ground Screw
F Threaded Stud (2)
CAUTION: BE SURE POWER IS OFF AT THE MAIN BREAKER BOX
PRIOR TO INSTALLATION.
1. Carefully unpack the fixture from the carton and thread
fix ture pipe (B) over fixture (A) wires.
2. Apply a drop of the supplied thread locking compound to
the internal threads of the fixture (A) and screw fixture pipe
(B) into fixture (A), being careful not to twist the wires.
Note: After installation extra hardware and accessories are possible
due to our kits are used on multiple products and options.
3. Thread the wires from the fixture pipe (A) into and through
the canopy pipe (H) up through the canopy (C).
4. Unscrew the clutch (J) from the canopy pipe (H); slide it
across the wires and onto the fixture pipe (B). Follow this
with the plastic clutch sleeve (I), oriented so the tapered end
of the clutch sleeve nests in the clutch.
5. Slide the canopy pipe (H) as far as necessary to give you
the total length of the fixture which you desire. Be
carful not to scratch the pipe surfaces and to pull excess
wire up through the canopy pipe (H). Screw clutch
(J) onto canopy pipe (H). There must be a minimum 1-1/2"
of inner pipe inside the outer pipe. Hand-tighten the
clutch to temporarily hold this adjustment. The clutch is not
securely fastened at this point; do not depend on it to hold
the fixture. Important: To ensure full connection strength,
be sure the tapered end of the plastic clutch sleeve (I)
A357
Pluto Pendant 18870 Page 1 of 3
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL INJURY OR DEATH AND
PROPERTY DAMAGE. We recommend installation by a licensed electrician. This product must be installed in accordance with
applicable installation code(s), by a person familiar with the construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
(Figure 1)
(Continued)
G
I
K
C
D
E
F
G Knurled Ball (2)
H Canopy Pipe
I Plastic Clutch Sleeve
J Clutch
K Set Screw
H
J
B
A