Hubbardton Forge 204212 - Manual

Installation Instructions
B32
For One Light Wall Sconce 20-4012 Page 1 of 2
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735 15020 Rev A
Please Note: This fixture is designed to be mounted on a standard wall surface and may not be suitable for all
applications. If installing in a non-wood frame application, we recommend consulting a qualified builder or electrician.
After installation extra hardware and accessories are possible; our kits are used on multiple products and options.
To Mount Fixture to Wall (Figure 1)
Component Parts
A Fixture
B Screw
Cap
C Nipple
D Lock
Nut
E Crossbar
F Ground
Screw
Caution: Be sure power is off at the main breaker box prior to installation.
1. Carefully unpack the fixture from the carton.
2. Using two machine screws (not provided)
attach cross bar (E) to the electric box.
Note: A new electric box comes with
screws. When replacing a fixture, retain the
screws for use with the new fixture.
3. Thread the nipple (C) into the crossbar and
secure with lock nut (D). Adjust the nipple
to proper length to ensure the fixture will fit
snugly to the wall.
4. Using suitable wire connectors (not
provided), connect the fixture wires to the
supply wires, (white to white, black to
black, bare copper or green to bare copper
or green). Ground the crossbar using the
green ground screw (F) to secure a pigtail
lead to the bracket.
If the fixture is wired with twin lead lamp
cord, connect the ribbed side to white, and
the smooth side to black.
Caution: Make sure wire connectors are
twisted on securely and no bare wires are exposed.
5. Carefully tuck all wires behind the fixture, place fixture
firmly against the wall and fasten screw cap (B).
6. See instructions following to install bulb and glass.
(continued)
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL
INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.
This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
Figure 1