Hubbardton Forge 207540 - Manual

Installation Instructions
B125
For Ellipse Sconces 20-7521, 207521F, 207531, 207531F, 20-7540 & 20-7540F Page 1 of 2
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735 20883
For fixtures requiring assembly, please refer to assembly instructions before installation.
Please Note: This fixture is designed to be mounted on a standard wall surface and may not be suitable for all
applications. If installing in a non-wood frame application, we recommend consulting a qualified builder or electrician.
To Mount Fixture to Wall (Figure 1)
Component Parts
A Crossbar
B Threaded Stud (2)
C Barrel Knob (2)
D Fixture
Assembly
E Ground Screw
Caution: Be sure power is off at the main breaker box prior to installation.
1. Carefully unpack the fixture from the carton.
2. Using two machine screws (not provided), fasten the
crossbar (A) to the electric box making sure that fixture
mounting holes are level.
Note: A new electric box comes with screws. When
replacing a fixture, retain the existing screws for use
with the new fixture.
3. Thread studs (B) into the appropriate holes in the
crossbar (A). Adjust the studs to proper length to ensure
the fixture will fit snugly to the wall.
4. Hold the fixture assembly (D) close to the wall and
using suitable wire connectors, not provided, connect
fixture wires to supply (white to white or ribbed and
black to black or smooth). Connect all ground wires to
ground screw.
Caution: Make sure wire connectors are twisted on
securely, and no bare wire is exposed.
5. Slide fixture assembly (D) over threaded studs (B) and
push firmly to wall, making sure that no wires are pinched
between fixture back and wall. Fasten with barrel knobs
(C). Be sure threaded studs (B) are fully seated in the
barrel knobs (C).
6. See instructions on next page to install glass.
(continued)
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL
INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.
This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
(Figure 1)
This illustration represents a typical fixture
and may not match every style.