Hubbardton Forge 207805 - Manual

Assembly & Installation Instructions
B265
Ondrian Wall Sconce 20-7801 & 20-7805 Page 1 of 2
Hand-Forged, Vermont-Made Lighting and Accessories
154 Route 30 South, Castleton, Vermont 05735 27214 B
Figure 1
Please Note: This fixture is designed to be mounted on a standard wall surface and may not be suitable for all
applications. If installing in a non-wood frame application, we recommend consulting a qualified builder or electrician.
To Mount Fixture to Wall (Figure 1)
Component Parts
A Wall Mounting Bracket D Electric Box Cover (for 4” Outlet box)
B Anchors (2) E # 8 Black Screw (3)
C #10 Screws (2) F Fixture Assembly
Caution: Be sure power is off at the main breaker box prior to
installation.
1. Carefully unpack the fixture from the carton.
2. Place the wall mounting bracket (A) over the electrical box using one
of the wiring holes provided being sure to hold it plum and level. If
using a single gang outlet box electric box, cover (D) is not needed.
Remove #8 black screw (E) from electric box cover (D) and save for
later use. Determine which electric box cover (D) location works the
best and attach to wall mounting bracket (A). With a pencil, mark the
location of all mounting holes in the wall mount bracket on the wall
behind.
IMPORTANT: Wall mounting bracket must be secured to a solidly
mounted to a framing member in at least two locations. Do not depend
on drywall anchors alone to support this fixture. If in doubt, contact a
qualified electrician.
Drill 1/4" holes in the locations marked on the wall. For holes using
anchors, place the tapered end of the anchors (B) into the holes and gently
tap them flush to the wall using a light weight hammer.
3. Thread the wires in the electrical box through the hole in the wall mounting bracket (A) while moving the bracket
into position. Using the 1" #10 screws (C), screw the bracket securely to the wall. Be careful not to over-tighten or
strip the anchors.
4. Hold the fixture assembly (F) close to the wall mounting bracket (A) and using suitable wire connectors (not
provided) connect fixture wires to supply wires (white to white, black to black, and bare copper or green to bare
copper or green). Ground the mounting bracket using the green ground wire fastened to the back of the fixture
assembly (F).
Caution: Make sure wire connectors are twisted on securely, and no bare wires are exposed.
5. Carefully tuck all wires behind the fixture assembly (F) and inside the wall mounting bracket (A) and place the
fixture over the bracket so the holes in the top and bottom match the threaded holes in the wall mounting bracket
(A). Secure the fixture by threading the #8 black screws (E) through the holes in the fixture assembly (F) and into
the wall mounting bracket (B).
6.
Install G-9 light bulbs (included)
Note: The bulb included is based on our design preference; see the fixtures wattage sticker for Max wattage
information
.
(continued)
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL
INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.
This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.