Hubbardton Forge 207873 - Manual

Installation & Assembly Instructions
B121
Exos Wave Three-Light Wall Sconce 20-7873
Page 1 of 2
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735 19912 Rev B
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL
INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.
This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
Please Note: This fixture is designed to be mounted on a standard wall surface and may not be suitable for all
applications. If installing in a non-wood frame application, we recommend consulting a qualified builder or electrician.
To Install Fixture (Figure 1)
Component Parts
A Wall Mount Bracket
B Anchors
(4)
C #10 Screws (4)
D Fixture
E #8 Black Screws (2)
F Green Ground Screw
G Cupped
Washer
Caution: Be sure power is off at the main
breaker box prior to installation.
1. Carefully unpack the fixture from the
carton.
2. Center the wall mount bracket (A)
over the electrical box being sure to
hold it plum and level. With a pencil,
mark the location of all mounting
holes in the wall mount bracket on the
wall behind.
IMPORTANT: Wall mount bracket
must be secured to a solidly mounted
electrical box and/or a framing
member in at least two locations. Do
not depend on drywall anchors alone
to support this fixture. If in doubt,
contact a qualified electrician.
Put the wall mount bracket down and
drill 1/4" holes in the locations
marked on the wall. For holes using
anchors, place the tapered end of the
anchors (B) into the holes and
gently tap them flush to the wall using a light weight hammer.
(Figure 1)
3. Thread the wires in the electrical box through the center hole in the wall mount bracket while moving the bracket
into position. Using the 1" #10 screws (C), screw the bracket securely to the wall. Be careful not to over-tighten or
strip the anchors.
4. Hold the fixture assembly (D) close to the wall mount bracket and using suitable wire connectors (not provided),
connect fixture wires to supply wires (white to white, black to black, and bare copper or green to bare copper or
green). Ground the mounting bracket using the green ground screw (F) and cupped washer (G) to secure a pigtail
lead to the bracket.
Caution: Make sure wire connectors are twisted on securely, and no bare wires are exposed.
(continued)