Hubbardton Forge 208023 - Manual

Installation Instructions
B241
Simple Lines Three-Light Sconce 20-8023 Page 1 of 1
Hand-Forged, Vermont-Made Lighting and Accessories
154 Route 30 South, Castleton, Vermont 05735 26947
Please Note: This fixture is designed to be mounted on a standard wall surface and may not be suitable for all
applications. If installing in a non-wood frame application, we recommend consulting a qualified builder or electrician.
To Mount Fixture to Wall and Install Glass (Figure 1)
Component Parts
A Crossbar F Knurled Balls (2)
B Ground Screw G Glass (3)
C Threaded Stud (2) H Retaining Ring (3)
D Fixture Assembly I Socket Tool
E Socket (3)
Caution: Be sure power is off at the main breaker
box prior to installation.
1. Carefully unpack the fixture from the carton.
2. Using two machine screws (not provided), fasten
the crossbar (A) to the electric box making sure
that fixture mounting holes are level.
Note: A new electric box comes with screws.
When replacing a fixture, retain the existing
screws for use with the new fixture.
3. Thread studs (C) into the appropriate holes in the
crossbar (A). Adjust the studs to proper length to
ensure the fixture will fit snugly to the wall.
4. Hold the fixture assembly (D) close to the wall
and using suitable wire connectors, not provided,
connect fixture wires to supply (white to white or
ribbed and black to black or smooth). Run a
pigtail lead from crossbar ground screw (B) to the
junction box and connect all ground wires (bare
copper or green to bare copper or green).
Caution: Make sure wire connectors are twisted on securely and no bare wire is exposed.
5. Slide fixture assembly (D) over threaded studs (C) and push firmly to wall, making sure that no wires are pinched
between fixture back and wall. Fasten with knurled balls (F). Be sure threaded studs (C) are fully seated in the
knurled balls (F).
6. Slide glass (G) over sockets (E) and secure retaining rings (H) using the socket tool (I).
Note: Retain socket too for future use.
7. Install light bulbs (not included) and restore electricity at main breaker
If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased
this product. We hope you enjoy your fixture!
*
Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL
INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.
This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
(Figure 1)