Hubbardton Forge 101283F - Manual

Assembly & Installation Instructions
A161
For Berceau Seven-Light Chandelier 10-1283F Page 1 of 2 _
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735 21249
Install the Canopy (Figure 1)
Component Parts
A Crossbar
B Threaded
Nipple
C Lag Screw (2)
D Lock
Nut
E Canopy
F Loop Collar
G Threaded Loop
H Chain
I Fixture
Loop
J Ground Screw
K Cupped Washer
L Hex Nut
Caution: Be sure power is off at the main breaker box prior to installation.
Caution: This fixture must be supported independently of an outlet box. Crossbar
is designed to fit in the bottom of a standard metal 4” octagonal outlet box.
1. Drill two holes through the back of the outlet box and using two lag screws
(C) attach cross bar (A) to a structural member in the ceiling, centering the
crossbar in the outlet box. We've supplied lag screws with your fixture;
however, different materials and/or construction methods may require
different fasteners. If in doubt, contact a qualified electrician.
2. Thread the nipple (B) into the crossbar (A).
3. Thread lock nut (D) and threaded loop (G) onto nipple, then place canopy
(E) over threaded loop and adjust nipple length to ensure a snug canopy fit.
Once the length is determined, set the canopy aside and lock nipple
position by tightening the locknut (D) against the crossbar (A).
4. Attach one end of the chain (H) to the fixture loop (I).
5. Attach the other end of the chain to the threaded loop (F) and thread the
fixture wires through every other link of the chain (H) and up through the
threaded loop (G) and nipple (B) into the outlet box.
6. Using suitable wire connectors (not provided), connect fixture wires to
supply wires (white or ribbed side of fixture cord to white supply, black or
smooth side of fixture cord to black supply, and bare copper to bare copper
or green supply). Ground the crossbar (A) using the ground screw (J),
cupped washer (K) and hex nut (L) to secure a pigtail lead to the crossbar.
Push wires back into outlet box.
Caution: Make sure wire connectors are twisted on securely, and no bare
wire is exposed.
7. Slide the canopy up the chain and over the threaded loop (G), securing
with loop collar (F). Make sure no wires are pinched between the canopy
(E) and the ceiling or crossbar (A).
(continued)
(Figure 1)
(Figure 1)
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL
INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.
This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.