Hubbardton Forge 19443000 - Manual

Assembly & Installation Instructions
A123
For Presidio Tryne Pendant 19-443000 Page 1 of 2 _
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735 19897
(Figure 1)
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL
INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.
This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
To Install the Canopy (Figures 1 & 2)
Component Parts
A Hang Plate
B Crossbar
C Lag Screw (4)
D Canopy
E Canopy
Cover
F Hex Nut (5)
G Support Rod (3)
H Threaded Studs (2)
I
Knurl Ball (2)
Caution: Be sure power is off at the main breaker box prior to installation.
Caution: This fixture must be supported independently of an outlet box.
See Figure 1 for Steps 1 thru 5
1. Carefully unpack the fixture from the carton.
2. Using at least two lag screws (C) attach cross bar (B) to a structural
member in the ceiling, centering the crossbar over the outlet box. We've
supplied lag screws with your fixture; however, different materials and/or
construction methods may require different fasteners. If in doubt, contact a
qualified electrician. Do not attach crossbar directly to outlet box.
3. Place canopy (D) over hang plate (A) and gently lower it so that it rests
against canopy cover (E) and body of fixture.
4. Push hang plate (A) at top of fixture up into electrical box, past the crossbar
(B). Turn the hang plate and drop the threaded studs in the hanger plate into
the larger inner holes in the crossbar. Make sure no wires are pinched.
5. Using suitable wire connectors (not provided), connect fixture wires to
supply wires (white or ribbed side of fixture cord to white supply, black or
smooth side of fixture cord to black supply, and bare copper to bare copper
or green supply). Push wires back into outlet box.
Caution: Make sure wire connectors are twisted on securely, and no bare
wire is exposed.
See Figure 2 for steps 6 thru 8
6. Insert three support rods (G) through outer holes in canopy (D).
7. Thread hex nut (F) onto support rod (G) until snug against inside of
canopy (D).
8. Slide canopy (D) up over the threaded studs in hang plate (A) and against
ceiling. Secure using two hex nuts (F).
See Figure 3 for Steps 9 thru 12
9. Start threaded studs (H) into threaded holes in crossbar (B).
10. Slide canopy cover (E) up over the threaded studs (H) and against the
canopy. Secure with the two knurled balls (I).
11. Refer to glass installation instructions and install glass. (Figure 1)
(continued)