Hubbardton Forge 19443600 - Manual

Assembly & Installation Instructions
A128
For Presidio Tryne Chandelier 19-443600 Page 1 of 3 _
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735 20378
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL
INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.
This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
To Attach Fixture Pipes (Figure 1)
Component Parts
A Pipe Assembly
B Canopy Cover
C Fixture Coupling
1. Carefully unpack the fixture from the carton.
2. Carefully slip pipe assembly (A) over fixture wires.
3. Slip canopy cover (B) over pipe assembly (A).
4. Apply a drop of the supplied thread locking compound to the
internal threads of the fixture coupling (B) and screw pipe
assembly (A) into fixture, being careful not to twist the wires.
Note: Application of the thread locking compound is necessary to
prevent the stem from loosening during regular maintenance
and cleaning of the fixture. Be certain to apply the compound.
5. See instructions below to complete the installation.
(Figure 1)
Install the Canopy (Figures 2 & 3)
Component Parts
B Canopy
Cover
D Hanger Plate
E Crossbar
F Lag Screw (4)
G Canopy
H 1/4-20 Hex Nut (5) I Threaded Rod (3)
J Threaded Stud (2)
K Knurl Ball (2)
Caution: Be sure power is off at the main breaker box prior to installation.
Caution: This fixture must be supported independently of an outlet box.
See Figure 2 for steps 1 thru 4
1. Using at least two lag screws (G) attach cross bar (E) to a structural member in the ceiling, centering the crossbar
over the outlet box. We've supplied lag screws with your fixture; however, different materials and/or construction
methods may require different fasteners. If in doubt, contact a qualified electrician. Do not attach crossbar directly
to outlet box.
(continued)