Hubbardton Forge 19443010 - Manual

Assembly & Installation Instructions
A129
For Tryne Chandelier 19-443010 & 19-443610 Page 1 of 3 _
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735 20610
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL
INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.
This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
To Attach Stem Assembly (Figure 1)
Component Parts
A Stem Assembly
B Fixture Coupling
1. Carefully unpack the fixture from the carton.
2. Carefully thread stem assembly (A), threaded end first, over fixture wires.
3. Apply a drop of the supplied thread locking compound to the internal threads of fixture
coupling (B) and screw into fixture, being careful not to twist the wires.
Note: Application of the thread locking compound is necessary to prevent the stem
from loosening during regular maintenance and cleaning of the fixture. Be certain to
apply the compound.
4. See instructions below to complete the installation. (Figure 1)
Install the Canopy (Figure 2)
Component Parts
C Crossbar
D Threaded
Nipple
E Lag Screw (2)
F Lock
Nut
G Canopy
H Loop Collar
I Threaded Loop
J Chain
K Fixture
Loop
Caution: Be sure power is off at the main breaker box prior to installation.
Caution: This fixture must be supported independently of an outlet box. Crossbar is designed
to fit in the bottom of a standard metal 4” octagonal outlet box.
1. Drill two holes through the back of the outlet box and using two lag screws (E) attach
cross bar (C) to a structural member in the ceiling, centering the crossbar in the outlet
box. We've supplied lag screws with your fixture; however, different materials and/or
construction methods may require different fasteners. If in doubt, contact a qualified
electrician.
2. Thread lock nut (F) and threaded loop (I) onto threaded nipple (D), then place canopy
(G) over threaded loop and adjust nipple length to ensure a snug canopy fit. Once the
length is determined, set the canopy aside and lock nipple position by tightening the
locknut (F) against the crossbar (C).
3. Attach one end of the chain (J) to the fixture loop (K).
(Figure 2)
(continued)