Hubbardton Forge 204350 - Manual

Installation Instructions
B288
Hobie Sconce 20-4350 Page 1 of 2
Hand-Forged, Vermont-Made Lighting and Accessories
154 Route 30 South, Castleton, Vermont 05735 28113
Please Note: This fixture is designed to be mounted on a standard wall surface and may not be suitable for all
applications. If installing in a non-wood frame application, we recommend consulting a qualified builder or electrician.
To Mount Fixture to Wall (Figure 1)
Component Parts
A Fixture Assembly
B Wall Mounting Bracket
C #8 Black Screws (4)
D Green Ground Screw
E Cupped Washer
Caution: Be sure power is off at the main breaker box prior to installation.
1. Carefully unpack the fixture from the carton.
2. Using two machine screws (not provided),
fasten the wall mounting bracket (B) to the
electric box making sure that fixture
mounting holes are level.
Note: A new electric box comes with screws.
When replacing a fixture, retain the existing
screws for use with the new fixture.
3. Thread the wires in the electrical box through
the center hole in the wall mount bracket.
4. Hold the fixture assembly (A) close to the
wall mount bracket (B) and, using suitable
wire connectors (not provided), connect
fixture wires to supply wires (white to white
or ribbed and black to black or smooth). Run
a pigtail lead from the green ground screw
(D) and cupped washer (E) and connect all
ground wires (bare copper or green to bare
copper or green).
Caution: Make sure wire connectors are
twisted on securely, and no bare wires are
exposed.
5. Carefully tuck all wires behind the fixture
assembly and inside the wall mount bracket and
place the fixture firmly onto mounting bracket (B)
and fasten with (2) #8 black screws on top (C).
6. To complete attachment of fixture, install remaining black screws (C) in bottom of fixture.
7. Complete steps below to install bulb and glass.
(continued)
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL
INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.
This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
(Figure 1)