Hubbardton Forge 204320 - Manual

Installation Instructions
B272
Echo Sconce 204320 Page 1 of 3
Hand-Forged, Vermont-Made Lighting and Accessories
154 Route 30 South, Castleton, Vermont 05735 27786 A
Caution: This fixture is designed to be mounted on a standard wall surface and may not be suitable for all applications. If
installing in a non-wood frame application, we recommend consulting a qualified builder or electrician.
To Mount Fixture to Standard Box (Figure 1)
Component Parts
A Crossbar
B Crossbar Ground Screw
C Threaded Studs Long (2)
D 4” Box Cover
E Fixture
F Threaded Knobs (2)
H Ground Screw
I
Cupped Washer
Caution: Be sure power is off at the main breaker
box prior to installation.
1. Carefully unpack the fixture from the carton.
2. Using two machine screws (not provided),
fasten the crossbar (A) to the electric box
making sure crossbar is level.
Note: A new electric box comes with screws.
When replacing a fixture, retain the existing
screws for use with the new fixture
.
3. Screw threaded studs (C) into the crossbar (A).
Adjust the threaded studs (C) to proper length to
ensure the fixture (E) will fit snugly to the wall.
4. Run a pigtail lead from crossbar ground screw
(B) to the junction box.
5. Slip the 4” box cover (D) onto the threaded studs (C).
6. Attach a pigtail lead to ground screw (H) and cupped washer (I).
7. Hold the fixture assembly (E) close to the wall and using suitable wire connectors (not provided) connect fixture
wires to supply (white to white or ribbed and black to black or smooth). Connect all ground wires (bare copper or
green to bare copper or green).
Caution: Make sure wire connectors are twisted on securely, and no bare wire is exposed.
8. Place fixture (E) firmly against the wall and fasten with threaded knobs (F).
9. See instructions on last page to install glass.
(continued)
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL
INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.
This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
(Figure 1)