Hubbardton Forge 204507 - Manual

Installation Instructions
B245
Tapered Pierced with Shade 20-4507 Page 1 of 2
Hand-Forged, Vermont-Made Lighting and Accessories
154 Route 30 South, Castleton, Vermont 05735 26951
Please Note: This fixture is designed to be mounted on a standard wall surface and may not be suitable for all
applications. If installing in a non-wood frame application, we recommend consulting a qualified builder or electrician.
To Mount Fixture to Wall (Figure 1)
Component Parts
A Crossbar
B Threaded Stud (2)
C Knurled Balls (2)
D Fixture
Assembly
E Ground Screw
Caution: Be sure power is off at the main
breaker box prior to installation.
1. Carefully unpack the fixture from the
carton.
2. Using two machine screws (not
provided), fasten the crossbar (A) to
the electric box making sure that
fixture mounting holes are level.
Note: A new electric box comes with
screws. When replacing a fixture,
retain the existing screws for use with
the new fixture.
3. Thread studs (B) into the appropriate
holes in the crossbar (A). Adjust the
studs to proper length to ensure the
fixture will fit snugly to the wall.
4. Hold the fixture assembly (D) close to
the wall and using suitable wire
connectors (not provided) connect fixture wires to supply (white to white or ribbed and black to black or smooth).
Run a pigtail lead from crossbar ground screw (E) to the junction box and connect all ground wires (bare copper
or green to bare copper or green).
Caution: Make sure wire connectors are twisted on securely, and no bare wire is exposed.
5. Slide fixture assembly (D) over threaded studs (B) and push firmly to wall, making sure that no wires are pinched
between fixture back and wall. Fasten with knurled balls (C). Be sure threaded studs (B) are fully seated in the
knurled balls (C).
6. See instructions on next page to install shade.
(continued)
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL
INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.
This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
(Figure 1)