Hubbardton Forge 204526 - Manual

Installation Instructions
B237
Sweeping Taper Sconce 20-4526 Page 1 of 3
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735 26943
Please Note: This fixture is designed to be mounted on a standard wall surface and may not be suitable for all
applications. If installing in a non-wood frame application, we recommend consulting a qualified builder or electrician.
After installation extra hardware and accessories are possible; our kits are used on multiple products and options.
To Mount Fixture to Wall with Single Box (Figure 1)
Component Parts
A Crossbar
B Ground
Screw
C Nipple
D Lock
Nut
E Threaded Cap
F Fixture Assembly
Caution: Be sure power is off at the main breaker box
prior to installation.
1. Carefully unpack the fixture from the carton.
2. Using two machine screws (not provided), fasten the
crossbar (A) to the electric box making sure crossbar
is level.
Note: A new electric box comes with screws. When
replacing a fixture, retain the existing screws for use
with the new fixture
.
3. Thread the nipple (C) into the crossbar (A) and secure
with lock nut (D). Adjust the nipple to proper length
to ensure the fixture will fit snugly to the wall.
4. Ground the crossbar (A) by securing a pigtail lead
around ground screw (B).
5. Hold the fixture assembly (F) close to the wall and
using suitable wire connectors, not provided, connect
fixture wires and pigtail leads to supply wires (white
to white or ribbed, black to black or smooth and green
to green or bare).
Caution: Make sure wire connectors are twisted on
securely, and no bare wire is exposed.
6. Carefully tuck all wires behind the fixture, place
fixture firmly against the wall and fasten with
threaded cap (E).
7. See instructions following to install wall plate.
(continued)
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL
INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.
This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
(Figure 1)