Hubbardton Forge 204506 - Manual

Installation Instructions
B234
Tapered Pierced 204506 Page 1 of 2
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735 26936
Caution: This fixture is designed to be mounted on a standard wall surface and may not be suitable for all applications. If
installing in a non-wood frame application, we recommend consulting a qualified builder or electrician.
Please Note: The hardware provided is intended for use in wood frame construction and may not be suitable for all
applications. If installing in non-wood frame applications, please consult a qualified builder to determine and obtain the
appropriate fasteners.
To Install Fixture (Figure 1)
Component Parts
A Ground Screw
B Crossbar
C Threaded Studs (2)
D Back
plate
E Knurled Balls (2)
Caution: Be sure power is off at the main
breaker box prior to installation.
1. Carefully unpack the fixture from the carton.
2. Using two machine screws (not provided), fasten the crossbar (B) to
the electric box (see illustration), making sure that fixture mounting holes are level.
Note: A new electric box comes with screws. When replacing a fixture, retain the existing screws for use with the
new fixture.
3. Thread studs (C) into appropriate holes in crossbar (B). Adjust the studs to proper length to ensure the back plate
(D) will fit snugly against the wall.
4. Using suitable wire connectors (not provided) connect fixture wires to supply wires (white to white and black to
black). If the fixture is wired with twin lead lamp cord, connect white to ribbed side of the fixtures cord, black to
smooth side. Run a pigtail lead from crossbar ground screw (A) to the junction box and connect all ground wires
(bare copper or green to bare copper or green).
Caution: Make sure wire connectors are twisted on securely, and no bare wire is exposed.
5. Slide back plate (D) over the threaded studs (C) and push firmly against the wall making sure that no wires are
pinched between back plate (D) and wall. Fasten with knurled balls (E). Be sure that threaded studs (C) are seated
in the knurled balls (E).
6. Install glass (see instructions below).
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL
INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.
This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
Figure 1