Hubbardton Forge 204712 - Manual

Installation Instructions
B190
For Antasia Sconce 20-4712L & 20-4112R Page 1 of 3
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735 22864
Please Note: This fixture is designed to be mounted on a standard wall surface and may not be suitable for all
applications. If installing in a non-wood frame application, we recommend consulting a qualified builder or electrician.
Please Note: After installation extra hardware and accessories are possible; our kits are used on multiple products and
options.
To Mount Fixture to Wall with Single Box (Figure 1)
Component Parts
A Crossbar
B Threaded
Stud
C Barrel Knob
D Fixture Assembly
E Ground Screw
F Cupped Washer
Caution: Be sure power is off at the main breaker box prior to installation.
1. Carefully unpack the fixture from the carton.
2. Using two machine screws (not provided),
fasten the crossbar (A) to the electric box
making sure crossbar is level.
Note: A new electric box comes with screws.
When replacing a fixture, retain the existing
screws for use with the new fixture.
3. Thread stud (B) into the appropriate hole in the
crossbar (A). Adjust the stud to proper length to
ensure the fixture will fit snugly to the wall.
4. Hold the fixture assembly (D) close to the wall
and using suitable wire connectors, not
provided, connect fixture wires to supply (white
to white or ribbed and black to black or
smooth). Ground the crossbar (A) using the
green ground screw (E) and cupped washer (F)
to secure a pigtail lead to the bracket. .
Caution: Make sure wire connectors are
twisted on securely, and no bare wire is
exposed.
5. Slide fixture assembly (D) over threaded stud
(B) and push firmly to wall, making sure that no
wires are pinched between fixture back and wall.
Fasten with barrel knob (C). Be sure threaded stud
(B) is fully seated in the barrel knob (C).
6. See instructions following to install glass.
(continued)
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL
INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.
This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
(Figure 1)