Hubbardton Forge 204915 - Manual

Installation Instructions
B208
For Twilight Sconce 20-4915 Page 1 of 3
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735 24453
Please Note: This fixture is designed to be mounted on a standard wall surface and may not be suitable for all
applications. If installing in a non-wood frame application, we recommend consulting a qualified builder or electrician.
After installation extra hardware and accessories are possible due to our kits are used on multiple products and options.
Prepare for installation (Figures 1)
Component Parts
A Fixture Front
B Thumb Screw (2)
1. Carefully unpack the fixture from the carton.
2. Remove fixture front (A) by loosening thumb screws (B). Assemblies
are shipped together. Slide fixture front (B) up to allow it to slip over
screws (B). Set aside for later use.
To Mount Fixture to Wall (Figures 2)
Component Parts
C Fixture Back
D Crossbar
E Threaded Stud (2)
F Knurl Ball (2)
G Ground
Screw
H Cupped Washer
Caution: Be sure power is off at the main breaker box prior
to installation.
1. Using two machine screws (not provided), fasten the
crossbar (D) to the electric box making sure that fixture
mounting holes are level.
Note: A new electric box
comes with screws. When replacing a fixture, retain the
existing screws for use with the new fixture.
2. Thread studs (E) into the appropriate holes in the
crossbar (D). Adjust the studs to proper length to ensure
the fixture will fit snugly to the wall.
3. Hold the fixture back (C) close to the wall and using
suitable wire connectors, not provided, connect fixture
wires to supply (white to white or ribbed and black to
black or smooth). Ground the crossbar using the green
ground screw (G) and cupped washer (H) to secure a pigtail
lead to the bracket.
Caution: Make sure wire connectors are twisted on securely, and no bare wire is exposed.
( continued)
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL
INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.
This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
(Figure 1)
(Figure 2)