Hubbardton Forge 205231 - Manual

H U B B A R D T O N F O R G E . C O M
hand-forged, vermont-made lighting and accessories
154 RT. 30 SOUTH • CASTLETON, VERMONT 05735
All designs and images ©1989-2013 Hubbardton Forge ® . All rights reserved. 19413 A
Installation Instructions
If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased this product.
We hope you enjoy your fixture!
* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.
Please Note: This fixture is designed to be mounted on a standard
wall surface and may not be suitable for all applications. If installing in
a non-wood frame application, we recommend consulting a qualified
builder or electrician.
To Mount Fixture to Wall and Install Glass (Figure 1)
Component Parts
A Crossbar F Leaf Assembly
B Ground Screw G Glass
C Threaded Stud (2) H Retaining Ring
D Fixture Assembly
E Knurled Ball (2)
CAUTION: BE SURE POWER IS OFF AT THE MAIN BREAKER BOX
PRIOR TO INSTALLATION.
1. Carefully unpack the fixture from the carton.
2. Using two machine screws (not provided), fasten the cross
bar (A) to the electric box making sure that fixture mounting
holes are level .
Note: A new electric box comes with screws. When replacing a
fixture, retain the existing screws for use with the new fixture.
3. Remove four screws (B) from front of fixture to release wall
mounting bracket and discard screws.
4. Hold the fixture assembly (D) close to the wall and using
suitable wire connectors, not provided, connect fixture
wires to supply (white to white or ribbed and black to black
or smooth). Run a pigtail lead from crossbar ground screw
(B) to the junction box and connect all ground wires (bare
copper or green to bare copper or green).
CAUTION: MAKE SURE WIRE CONNECTORS ARE TWISTED ON
SECURELY, AND NO BARE WIRE IS EXPOSED.
5. Slide fixture assembly (D) over threaded studs (C) and push
firmly to wall, making sure that no wires are pinched
between fixture back and wall. Fasten with knurled balls (E).
Be sure threaded studs (C) are fully seated in the knurled
balls (E).
B73
Twining Leaf Sconce 205231 Page 1 of 2
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL INJURY OR DEATH AND
PROPERTY DAMAGE. We recommend installation by a licensed electrician. This product must be installed in accordance with
applicable installation code(s), by a person familiar with the construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
(Figure 1)
(Continued)
A
B
C
D
E
F
G
H