Hubbardton Forge 205315 - Manual

Installation Instructions
B263
Calla Sconce with Shade 20-5315 Page 1 of 2
Hand-Forged, Vermont-Made Lighting and Accessories
154 Route 30 South, Castleton, Vermont 05735 27151
Please Note: This fixture is designed to be mounted on a standard wall surface and may not be suitable for all
applications. If installing in a non-wood frame application, we recommend consulting a qualified builder or electrician.
To Mount Fixture to Wall (Figure 1)
Component Parts
A Crossbar
B Threaded Stud (2)
C Knurled Ball (2)
D Fixture
Assembly
E Ground Screw
Caution: Be sure power is off at the main breaker box prior to installation.
1. Carefully unpack the fixture from the carton.
2. Using two machine screws (not provided),
fasten the crossbar (A) to the electric box
making sure that fixture mounting holes are
level.
Note: A new electric box comes with screws.
When replacing a fixture, retain the existing
screws for use with the new fixture.
3. Thread studs (B) into the appropriate holes in
the crossbar (A). Adjust the studs to proper
length to ensure the fixture will fit snugly to
the wall.
4. Hold the fixture (D) close to the wall and
using suitable wire connectors, not provided,
connect fixture wires to supply (white to white
or ribbed and black to black or smooth). Run a
pigtail lead from crossbar ground screw (E) to
the junction box and connect all ground wires
(bare copper or green to bare copper or green).
Caution: Make sure wire connectors are
twisted on securely, and no bare wire is
exposed.
5. Slide fixture assembly (D) over threaded studs
(B) and push firmly to wall, making sure that
no wires are pinched between fixture back and
wall. Fasten with knurled balls (C). Be sure
threaded studs (B) are fully seated in the
knurled balls (C).
6. See instructions on next page to install shade.
(continued)
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL
INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.
This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
(Figure 1)