Hubbardton Forge 205750 - Manual

Installation Instructions
B74
Forged Reeds Sconce 20-5750 & 20-5750F Page 1 of 1
Hand-Forged, Vermont-Made Lighting and Accessories
154 Route 30 South, Castleton, Vermont 05735 19414
Please Note: This fixture is designed to be mounted on a standard wall surface and may not be suitable for all
applications. If installing in a non-wood frame application, we recommend consulting a qualified builder or electrician.
To Mount Fixture to Wall and Install Glass (Figure 1)
Component Parts
A Glass E Decorative Cage
B Ground Screw F Knurled Ball (2)
C Crossbar G Fixture Assembly
D Threaded Stud (2)
Caution: Be sure power is off at the main breaker box prior to
installation.
1. Carefully unpack the fixture from the carton.
2. Using two machine screws (not provided), fasten the crossbar (C)
to the electric box making sure that fixture mounting holes are
level.
Note: A new electric box comes with screws. When replacing a
fixture, retain the existing screws for use with the new fixture.
3. Thread studs (D) into the appropriate holes in the crossbar (C).
Adjust the studs to proper length to ensure the fixture will fit
snugly to the wall.
4. Hold the fixture assembly (G) close to the wall and using suitable
wire connectors, not provided, connect fixture wires to supply
(white to white or ribbed and black to black or smooth). Run a
pigtail lead from crossbar ground screw (B) to the junction box
and connect all ground wires (bare copper or green to bare copper
or green).
Caution: Make sure wire connectors are twisted on
securely, and no bare wire is exposed.
5. Slide fixture assembly (G) over threaded studs (D) and push firmly
to wall, making sure that no wires are pinched between fixture back
and wall. Fasten with knurled balls (F). Be sure threaded studs (D)
are fully seated in the knurled balls (F).
6. Install light bulb (not included/GU24 bulb included on F version)
7. Slide glass (A) downward slowly into decorative cage (E). Glass will stop once it rests on the base tabs.
Note: If you have difficulty sliding the glass behind the decorative cage on this fixture, the cage may have been
slightly bent during shipping. To install the glass, simply pull the decorative wire cage away from the backplate
allowing the glass to slide behind it.
8. Restore electricity at main breaker.
If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased
this product. We hope you enjoy your fixture!
* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL
INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.
This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
(Figure 1)