Hubbardton Forge 206032 - Manual

Fixture Assembly & Installation Instructions
B44
Page 1 of 3
Component Parts
A Glass
B Oval Frame
C Retaining Clips
D Blinders
E Screws
To Install Glass in Frame
1. Remove retaining clips (C) from oval frame (B) making note of how they are attached to the frame. Depending on
the fixture style, there may be one or two clips. Note that there is a left clip and a right clip. The clips are slanted to
follow the edge of the glass.
2. Slide glass (A) into frame.
3. Keeping glass centered in frame, return clips to frame, slide inward so they grasp the edge of the glass and tighten
the screws to hold the clips in place.
4. Slide blinders (D) outward so the edge of the blinder is positioned just inside the outer edge of the glass, and secure
by tightening screws. The purpose of the blinders is to eliminate glare on the mounting surface.
5. Please refer to Fixture Installation Instructions on next page prior to attaching frame to fixture.
(continued)
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735 16046 RevA