Hubbardton Forge 205770 - Manual

H U B B A R D T O N F O R G E . C O M
hand-forged, vermont-made lighting and accessories
154 RT. 30 SOUTH • CASTLETON, VERMONT 05735
All designs and images ©1989-2013 Hubbardton Forge ® . All rights reserved. 20160 A
Installation Instructions
If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased this product.
We hope you enjoy your fixture!
* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.
CAUTION: THIS FIXTURE IS DESIGNED TO BE MOUNTED ON A
STANDARD WALL SURFACE AND MAY NOT BE SUITABLE FOR ALL
APPLICATIONS. IF INSTALLING IN A NON-WOOD FRAME APPLICA-
TION, WE RECOMMEND CONSULTING A QUALIFIED BUILDER OR
ELECTRICIAN.
Please Note: The hardware provided is intended for use in wood frame
construction and may not be suitable for all applications. If installing
in non-wood frame applications, please consult a qualified builder to
determine and obtain the appropriate fasteners.
To Install Fixture (Figure 1)
Component Parts
A Knurled Balls (2)
B Threaded Studs (2)
C Ground Screw
D Crossbar
E Fixture
CAUTION: BE SURE POWER IS OFF AT THE MAIN BREAKER BOX
PRIOR TO INSTALLATION.
1. Carefully unpack the fixture from the carton.
2. Using two machine screws (not provided), fasten the cross
bar (D) to the electric box (see illustration), making sure that
fixture mounting holes are level.
Note: A new electric box comes with screws. When replacing a
fixture, retain the existing screws for use with the new fixture.
3. Thread studs (B) into the appropriate holes in the crossbar
(D). Adjust the studs to proper length to ensure the fixture
will fit snugly to the wall.
4. Using suitable wire connectors (not provided) connect
fixture wires to supply wires (white to white and black to
black). If the fixture is wired with twin lead lamp cord,
connect white to ribbed side of the fixtures cord, black to
smooth side. Run a pigtail lead from crossbar ground screw
(C) to the junction box and connect all ground wires (bare
copper or green to bare copper or green).
B122
Forged Leaf and Stem Sconce 205770L & 205770R Page 1 of 3
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL INJURY OR DEATH AND
PROPERTY DAMAGE. We recommend installation by a licensed electrician. This product must be installed in accordance with
applicable installation code(s), by a person familiar with the construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
(Figure 1)
(Continued)
C
D
B
A
E