Hubbardton Forge 206551 - Manual

Installation Instructions
B244
Suspended Half Cone Sconce 20-6551 & 20-6551F Page 1 of 1
Hand-Forged, Vermont-Made Lighting and Accessories
154 Route 30 South, Castleton, Vermont 05735 26950
Please Note: This fixture is designed to be mounted on a standard wall surface and may not be suitable for all
applications. If installing in a non-wood frame application, we recommend consulting a qualified builder or electrician.
To Mount Fixture to Wall and Install Glass (Figure 1)
Component Parts
A Glass D Ground Screw
B Forged Bar E Mounting Screw (2)
C Crossbar F Fixture Assembly
Caution: Be sure power is off at the main breaker box
prior to installation.
1. Carefully unpack the fixture from the carton.
2. Using two machine screws (not provided), fasten the
crossbar (C) to the electric box making sure that
fixture mounting holes are level.
Note: A new electric box comes with screws. When
replacing a fixture, retain the existing screws for use
with the new fixture.
3. Hold the fixture assembly (F) close to the wall and
using suitable wire connectors, not provided,
connect fixture wires to supply (white to white or
ribbed and black to black or smooth). Run a pigtail
lead from crossbar ground screw (D) to the junction
box and connect all ground wires (bare copper or
green to bare copper or green).
Caution: Make sure wire connectors are twisted on
securely, and no bare wire is exposed.
4. Push fixture assembly firmly to wall, making sure
that no wires are pinched between fixture back and
wall. Align mounting screws (E) with holes in
fixture back and thread into crossbar (C) until fixture
is tight against the wall.
5. Install light bulb (GU24 included on F version)
6. Slide glass (A) downward into fixture and adjust so
it is level and flush against the high point on the curve of
the fixture (B).
7. Restore electricity at main breaker
If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased
this product. We hope you enjoy your fixture!
*
Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL
INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.
This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
(Figure 1)