Hubbardton Forge 206563 - Manual

Installation Instructions
B80
Half Cone with Sweep Sconce 20-6563 Page 1 of 1
Hand-Forged, Vermont-Made Lighting and Accessories
154 Route 30 South, Castleton, Vermont 05735 19420 Rev A
Please Note: This fixture is designed to be mounted on a standard wall surface and may not be suitable for all
applications. If installing in a non-wood frame application, we recommend consulting a qualified builder or electrician.
To Mount Fixture to Wall and Install Glass (Figure 1)
Component Parts
A Glass
B Thumb Screw (2)
C Crossbar
D Ground Screw
E Fixture Assembly
F Forged Front Piece
G #8 Screws
Caution: Be sure power is off at the main breaker box prior to
installation.
1. Carefully unpack the fixture from the carton.
2. Using two machine screws (not provided), fasten the crossbar (C) to
the electric box making sure that fixture mounting holes are level.
Note: A new electric box comes with screws. When replacing a
fixture, retain the existing screws for use with the new fixture.
3. Hold the fixture assembly (E) close to the wall and using suitable
wire connectors, not provided, connect fixture wires to supply (white
to white or ribbed and black to black or smooth). Run a pigtail lead
from crossbar ground screw (D) to the junction box and connect all
ground wires (bare copper or green to bare copper
or green).
Caution: Make sure wire connectors are twisted on
securely, and no bare wire is exposed.
4. Carefully tuck all wires behind the fixture, place fixture firmly
against the wall and fasten with two #8 screws (G).
5. Install light bulb(s). Not Included
6. Slide glass (A) downward into fixture and adjust so it is flush against the high
point on the curve of the fixture (E).
7. Level and adjust the glass (A) so there is approx. ¼
″ between it and the wall on all sides.
8. Snug the thumb screws (B) against the inside face of glass (A). Do not over tighten.
9. Restore electricity at main breaker.
If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased
this product. We hope you enjoy your fixture!
* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL
INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.
This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
(Figure 1)