Hubbardton Forge 207861 - Manual

Assembly & Installation Instructions
B65
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735 17725 Rev F
For Bracket-Mounted After Hours Sconces Page 1 of 3
For fixtures requiring assembly, please refer to assembly instructions before installation.
Please Note: This fixture is designed to be mounted on a standard wall surface and may not be suitable for all
applications. If installing in a non-wood frame application, we recommend consulting a qualified builder or electrician.
To Mount Fixture to Wall (Figure 1)
Component Parts
A Wall Mounting Bracket
B Anchors
(4)
C #10 Screws (4)
D Electric Box Cover (for
4” Outlet box)
E #8 Black Screws (3)
F Fixture
Assembly
Caution: Be sure power is off at the main breaker box prior to
installation.
1. Carefully unpack the fixture from the carton.
2. Place the wall mounting bracket (A) over the electrical box using one
of the wiring holes provided being sure to hold it plum and level. If
using a single gang outlet box electric box, cover (D) is not
needed. Remove #8 black screw (E) from electric box cover (D) and
save for later use. Determine which electric box cover (D) location
works the best and attach to wall mounting bracket (A) using #8
black screw (E). With a pencil, mark the location of all mounting
holes in the wall mount bracket on the wall behind.
IMPORTANT: Wall mounting bracket must be secured to a solidly
mounted to a framing member in at least two locations. Do not
depend on drywall anchors alone to support this fixture. If in doubt,
contact a qualified electrician.
Drill 1/4" holes in the locations marked on the wall. For holes using
anchors, place the tapered end of the anchors (B) into the holes and
gently tap them flush to the wall using a light weight hammer.
3. Thread the wires in the electrical box through the hole in the wall mounting bracket (A) while moving the bracket
into position. Using the 1" #10 screws (C), screw the bracket securely to the wall. Be careful not to over-tighten or
strip the anchors.
4. Hold the fixture assembly (F) close to the wall mounting bracket (A) and using suitable wire connectors (not
provided) connect fixture wires to supply wires (white to white, black to black, and bare copper or green to bare
copper or green). Ground the mounting bracket using the green ground wire fastened to the back of the fixture
assembly (F).
Caution: Make sure wire connectors are twisted on securely, and no bare wires are exposed.
5. Carefully tuck all wires behind the fixture assembly (F) and inside the wall mounting bracket (A) and place the
fixture over the bracket so the holes in the top and bottom match the threaded holes in the wall mounting bracket
(A). Secure the fixture by threading the #8 black screws (E) through the holes in the fixture assembly (F) and into
the wall mounting bracket (B).
6. Install light bulbs. (See bulb installation at the end of the instructions.)
(continued)
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL
INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.
This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
(Figure 1)