Hubbardton Forge 213256 - Manual

Installation Instructions
B228
Tapered Angle Sconce 21-3255 & 21-3256 Page 1 of 2
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735 26784
Caution: This fixture is designed to be mounted on a standard wall surface and may not be suitable for all applications. If
installing in a non-wood frame application, we recommend consulting a qualified builder or electrician.
To Install Back plate (Figure 1)
Component Parts
A Cross Bar
B Threaded Studs (2)
C Ground
Screw
D Fixture Assembly
E Barrel Knobs (2)
Caution: Be sure power is off at the main breaker box prior to installation.
1. Carefully unpack the fixture from the carton.
2. Using two machine screws (not provided),
fasten the crossbar (A) to the electric box (see
illustration), making sure that fixture
mounting holes are level.
Note: A new electric box comes with screws.
When replacing a fixture, retain the existing
screws for use with the new fixture.
3. Thread studs (B) into appropriate holes in
crossbar (A). Adjust the studs to proper length
to ensure the fixture assembly (D) will fit
snugly against the wall.
4. Using suitable wire connectors (not provided)
connect fixture wires to supply wires (white to
white and black to black). Run a pigtail lead
from crossbar ground screw (C) to the
junction box and connect all ground wires
(bare copper or green to bare copper or green).
Caution: Make sure wire connectors are
twisted on securely, and no bare wire is
exposed.
5. Slide fixture assembly (D) over the threaded
studs (B) and push firmly against the wall
making sure that no wires are pinched
between back plate and wall. Fasten with
barrel knobs (E). Be sure that threaded studs
(B) are seated in the barrel knobs (E).
6. Install bulb and decorative face plates (see instructions below).
(continued)
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL
INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.
This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
(Figure 1)