Hubbardton Forge 213310 - Manual

Installation Instructions
B256
Oculus Sconce/Semi-flush 21-3310 Page 1 of 3
Hand-Forged, Vermont-Made Lighting and Accessories
154 Route 30 South, Castleton, Vermont 05735 27014
Please Note: This fixture is designed to be mounted on a standard wall surface and may not be suitable for all
applications. If installing in a non-wood frame application, we recommend consulting a qualified builder or electrician.
After installation extra hardware and accessories are possible; our kits are used on multiple products and options.
To Prepare Fixture (Figure 1)
Component Parts
A Fixture
B Forged
Cone Assembly
1. Carefully unpack the fixture from the carton.
2. Spin forged cone assembly (B) counterclockwise until it separates
from the fixture (A).
3. Set aside for later use.
To Mount Fixture to Wall (Figure 2)
Component Parts
A Fixture
C Crossbar
D Threaded Stud (2)
E Knurled Ball (2)
F Ground
Screw
Caution: Be sure power is off at the main breaker box
prior to installation.
1. Using two machine screws (not provided), fasten the
crossbar (C) to the electric box making sure that
fixture mounting holes are level.
Note: A new
electric box comes with screws. When replacing a
fixture, retain the existing screws for use with the new
fixture.
2. Thread studs (D) into the appropriate holes in the
crossbar (C). Adjust the studs to proper length to
ensure the fixture will fit snugly to the wall.
3. Hold the fixture (A) close to the wall and using suitable wire connectors, not provided, connect fixture wires to
supply (white to white or ribbed and black to black or smooth). Run a pigtail lead from crossbar ground screw (F)
to the junction box and connect all ground wires (bare copper or green to bare copper or green).
Caution: Make sure wire connectors are twisted on securely, and no bare wire is exposed.
4. Slide fixture (A) over threaded studs (D) and push firmly to wall, making sure that no wires are pinched between
fixture and wall. Fasten with knurled balls (E). Be sure threaded studs (D) are fully seated in the knurled balls (E).
5. See instructions following to complete installation.
( continued)
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL
INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.
This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
(Figure 2)
(Figure 1)