Hubbardton Forge 217510 - Manual

Installation Instructions
B176
For Aperture Sconce 21-7510 Page 1 of 3
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735 22736 Rev A
Please Note: This fixture is designed to be mounted on a standard wall surface and
may not be suitable for all applications. If installing in a non-wood frame application,
we recommend consulting a qualified builder or electrician.
Please Note: After installation extra hardware and accessories are possible; our kits
are used on multiple products and options.
To Mount Fixture to Wall (Figures 1 & 2)
Component Parts
A Fixture Back
B Fixture Front
C Locking Screw
D Cap Screw (2)
E Screw
Cap
F Nipple
G Lock
Nut
H Crossbar
I Ground
Screw
Caution: Be sure power is off at the main breaker box prior to installation.
1. Carefully unpack the fixture from the carton.
2. Remove fixture front (B) from fixture back (A) by loosening locking
screw (C). Note: It is not necessary to remove locking screw (C). Two
assemblies are shipped together. Slide fixture front (B) up to allow it to slip
over cap screws (D). Set aside for later use.
3. Using two machine screws (not provided) attach cross bar (H) to the electric
box. Note: A new electric box comes with screws. When replacing a fixture,
retain the screws for use with the new fixture.
4. Thread the nipple (F) into the crossbar and secure
with lock nut (G). Adjust the nipple to proper length
to ensure the fixture will fit snugly to the wall.
5. Using suitable wire connectors (not provided),
connect the fixture wires to the supply wires, (white
to white, black to black, bare copper or green to bare
copper or green). If the fixture is wired with twin lead
lamp cord, connect the ribbed side to white, and the
smooth side to black.
Caution: Make sure wire connectors are twisted on
securely and no bare wires are exposed.
6. Carefully tuck all wires behind the fixture, place
fixture firmly against the wall and fasten screw
cap (E).
7. See instructions following to complete install.
(continued)
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL
INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.
This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
Figure 1
Figure 2