Hubbardton Forge 217640 - Manual

Installation Instructions
B56
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735 17692 Rev D
Bracket Mounted Gallery Sconces
For fixtures requiring assembly, please refer to assembly instructions before installation.
Please Note: This fixture is designed to be mounted on a standard wall surface and may not be suitable for all
applications. If installing in a non-wood frame application, we recommend consulting a qualified builder or electrician.
Component Parts
A Anchors (6)
B Wall Mounting Bracket
C Ground
D #10 Screws (6)
E Standoff
(4)
F Fixture Can Assembly
G #8 x 1” Long Screws (4)
To Install
Caution: Be sure power is off at the main breaker box prior to installation.
1. Carefully unpack the fixture from the carton.
2. Place the wall mounting bracket (B) over the electrical box using one
of three holes provided being sure to hold it plum and level. With a
pencil, mark the location of all mounting holes in the wall mount
bracket on the wall behind.
IMPORTANT: Wall mounting bracket must be secured to a solidly
mounted electrical box and/or a framing member in at least two
locations. Do not depend on drywall anchors alone to support this
fixture. If in doubt, contact a qualified electrician.
Set aside the wall mounting bracket and drill 1/4" holes in the locations
marked on the wall. For holes using anchors, place the tapered end of
the anchors (A) into the holes and gently tap them flush to the wall
using a light weight hammer.
3. Thread the wires in the electrical box through the hole in the wall
mounting bracket (B) while moving the bracket into position. Using the
1" #10 screws (D), screw the bracket securely to the wall. Be careful
not to over-tighten or strip the anchors.
4. Hold the fixture can assembly (F) close to the wall mounting bracket
(B) and using suitable wire connectors (not provided), connect fixture wires to supply wires (white to white, black
to black, and bare copper or green to bare copper or green). Ground the mounting bracket using the ground (C)
mounted to the wall mounting bracket (B).
Caution: Make sure wire connectors are twisted on securely, and no bare wires are exposed.
5. Carefully tuck all wires behind the fixture can assembly (F) and inside the wall mounting bracket (B) and place
the fixture over the bracket so the holes in the top and bottom match the threaded standoffs (E) protruding from
the wall mounting bracket (B). Secure the fixture by threading the #8 black screws (G) through the holes in the
fixture can assembly (F) and into the wall mounting bracket (B).
6. Refer to glass and front mounting instructions for complete installation.
If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased
this product. We hope you enjoy your fixture!
* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL
INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.
This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.