Hubbardton Forge 217653 - Manual

Installation Instructions
B130
For Gallery Sconce 21-7653F Page 1 of 3
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735 21124
For fixtures requiring assembly, please refer to assembly instructions before installation.
Please Note: This fixture is designed to be mounted on a standard wall surface and may not be
suitable for all applications. If installing in a non-wood frame application, we recommend consulting a
qualified builder or electrician.
To Install (Figure 1)
Component Parts
A Fixture
B Screws
(4)
Caution: Be sure power is off at the main breaker box prior to installation.
1. Carefully unpack the fixture from the carton.
2. Remove four screws (B) from front of fixture to release wall mounting bracket and discard
screws.
To Install Wall Mounting Bracket (Figure 2)
Component Parts
C Wall Mounting Bracket
D Anchors
(10)
E #10 Screws (10)
1.
Place the wall mounting bracket (C) over the electrical box using the center hole provided
being sure to hold it plum and level. With a pencil, mark the location of all mounting
holes in the wall mount bracket on the wall behind.
IMPORTANT: Wall mounting bracket must be secured to a solid framing member in at
least four locations. Do not depend on drywall anchors alone to support this fixture. If in
doubt, contact a qualified electrician.
Set aside the wall mounting bracket and drill 1/4" holes in the locations marked on the
wall. For holes using anchors, place the tapered end of the anchors (D) into the holes and
gently tap them flush to the wall using a light weight hammer.
2. Thread the wires in the electrical box through the hole in the wall mounting bracket (C)
while moving the bracket into position. Using the 1" #10 screws (E), screw the bracket
securely to the wall. Be careful not to over-tighten or strip the anchors.
(continued)
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL
INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.
This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
(Figure 1)
(Figure 2)