Hubbardton Forge 236401 - Manual

Installation Instructions
C31
Axis Table & Floor Lamp 23-6401, 23-6401C, 26-6401, 26-6401C, 26-6403 & 26-6403C
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735 24614
Install Bottom Diffusers
(Figure 1)
Component Parts
A Lamp
B Bottom
Diffuser
1. Carefully unpack the lamp from the carton.
2. Place bottom diffuser (B) on lamp (A) by angling it until it slips
over the sockets and rests on the three arms of the lamp (A).
Install Shade and Top Diffuser (Figure 2)
Component Parts
C Threaded Stud
D Shade
E Washer
F Top
Diffuser
G Finial
1. Set shade (D) on fixture so it rests on all three supports.
2. For best appearance, we recommend locating shade seam directly
behind one of the bars of the lamp. This will eliminate the seam
shadow.
3. Install bulbs. “C” version bulbs are included.
4. Slip washer (E) over threaded stud (C).
5. Slip top diffuser (F) onto threaded stud (C) so it rests on top of
washer (E).
6. Thread finial (G) onto threaded stud (C) and tighten until snug to
top diffuser (F). Be careful not to over tighten.
If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased
this product. We hope you enjoy your fixture!
* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.
Figure 1
Figure 2