Hubbardton Forge 244101 - Manual

H U B B A R D T O N F O R G E . C O M
hand-forged, vermont-made lighting and accessories
154 RT. 30 SOUTH • CASTLETON, VERMONT 05735
All designs and images ©1989-2014 Hubbardton Forge ® . All rights reserved. 30902
Shade Installation Instructions
If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased this product.
We hope you enjoy your fixture!
* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.
To Assembly Fixture (Figure 1)
Component Parts
A Fixture Bottom
B Fixture Top
C Tabletop
D Nylon Washer (4)
E #8 Screw (2)
F Sq. Cap
G Quick Connect
1. Carefully unpack the lamp from the carton.
2. Remove #8 screw (E) and one of the nylon washers (D) from
the fixture top (B). Remove the #8 screw (E), one of the
nylon washers (D) and the sq. cap (F) from fixture bottom (A).
The screws are shipped installed.
3. Locate quick connect on fixture bottom (A). Place a nylon
washer (D) over the quick connect (G) and onto the
fixture bottom (A).
4. Pull half of quick connect (G) through one hole in the table
top (C) and gently set tabletop (C) on top of nylon washers
(D) on fixture bottom (A).
5. Place another nylon washer (D) over the quick connect (G)
and set on top of tabletop (C).
6. Locate the half of the quick connect (G) located on the fix-
ture top (B).
7. Holding the fixture top (B) and fixture bottom (A) close
together, plug the two ends of the quick connect (G)
together.
8. Carefully slide fixture top (B) down through nylon washer (D),
tabletop (C), second nylon washer (D) and into fixture
bottom (A).
9. Align threaded hole with slot. Secure by threading #8 screw
(E) into fixture bottom (A).
10. Place another nylon washer (D) over other leg of fixture
bottom (A) on top of tabletop (C).
11. Push sq. cap (F) through nylon washer (D), table top (C),
second nylon washer (D) and into fixture bottom (A).
12. Align threaded hole with slot. Secure with second #8 screw
(E).
C64
Balance Floor Lamp 244101 & 244101C Page 1 of 2
(Figure 1)
D
F
G
C
E
A
Continued
B