Hubbardton Forge 124247 - Manual

Installation Instructions
A34
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735 14532 Rev A
For Semi Flush Pendants with Slide Locking Mechanism Page 1 of 2
For fixtures requiring assembly, please refer to assembly instructions prior to installation.
Component Parts
A Canopy
B
Electric Box Machine Screws (not provided)
C Black or Smooth Wires
D Ground Wires
E White or Ribbed Wires
F Round Cross Bar
G 8-32 Threaded Studs
H 8-32 Knurled Balls
I Wire Nuts or connectors (not provided)
J Green Ground Screw
To Install
Caution: Be sure power is off at the main breaker box prior to installation
1. Carefully unpack the fixture from the carton.
2. Thread studs (G) through appropriate holes in cross bar
(F) to match hole centers in canopy (A). Move ground
screw (J) to another available threaded hole if
necessary.
3. Using two machine screws (B, not provided) fasten
cross bar to the electric box using outer oval holes to
orient fixture to desired hanging position.
Note: A new electric box comes with screws. When
replacing an existing fixture, retain the screws for use with
the new fixture.
5. Using suitable wire connectors (I) (not provided),
connect fixture wires to supply wires (white to white or
ribbed (E) and black to black or smooth (C). Connect
all ground wires (D) to green ground screw (J).
Caution: Make sure wire connectors are twisted on
securely, and no bare wire is exposed.
6. Slide fixture canopy (A) over threaded studs and push
firmly to ceiling, making sure that no wires are pinched
between fixture canopy and ceiling. Fasten with
knurled balls (H). Be sure studs (G) are fully seated in the knurled balls (H).
7. Install light bulb(s) (not provided).
8. Install glass (refer to glass installation instructions if appropriate).
9. Restore electricity at main breaker.
(continued)
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL
INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.
This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.