Hubbardton Forge 124255 - Manual

Assembly & Installation Instructions
A332
Moonband Semi-Flush 124255 Page 1 of 2
Hand-Forged, Vermont-Made Lighting and Accessories
154 Route 30 South, Castleton, Vermont 05735 28306
To Install Fixture (Figure 1)
Component Parts
A Canopy
B Cross Bar
C Threaded Stud (3)
D Barrel Knobs (3)
E Ground screw
Caution: Be sure power is off at the main
breaker box prior to installation
1. Carefully unpack the fixture from the
carton.
2. Thread studs (C) through appropriate
holes in cross bar (B) to match hole
centers in canopy (A). Move ground
screw (E) to another available threaded
hole if necessary.
3. Using two machine screws (not
provided) fasten cross bar (B) to the
electric box using outer oval holes to
orient fixture to desired hanging position.
Note: A new electric box comes with
screws. When replacing an existing
fixture, retain the screws for use with the
new fixture.
4. Using suitable wire connectors (not
provided); connect fixture wires to
supply wires (white to white and black to
black). Connect all ground wires to green
ground screw (E).
Caution: Make sure wire connectors are
twisted on securely, and no bare wire is exposed.
5. Slide fixture canopy (A) over threaded studs and push firmly to ceiling, making sure that no wires are pinched
between fixture canopy and ceiling. Fasten with barrel knobs (D). Be sure studs (C) are fully seated in barrel
knobs (E).
(continued)
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL
INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.
This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
(Figure 1)