Hubbardton Forge 124394 - Manual

Installation Instructions
A301
Banded Flush Mount 12-4394 Page 1 of 2
Hand-Forged, Vermont-Made Lighting and Accessories
154 Route 30 South, Castleton, Vermont 05735
27152
To Install Fixture (Figure 1)
Component Parts
A Crossbar
B Ground
Screw
C Threaded Stud (2)
D Fixture
E
Knurl Ball (2)
F Safety Cable
G Screw
H Hex
Nut
Caution: Be sure power is off at the main breaker box prior to installation
1. Carefully unpack the fixture from the carton.
2. Thread studs (C) through appropriate holes in cross
bar (A) to match hole centers in fixture (D). Move
ground screw (B) to another available threaded hole
if necessary.
3. Using two machine screws (not provided) fasten
cross bar (A) to the electric box using outer oval
holes to orient fixture to desired hanging position.
Note: A new electric box comes with screws. When
replacing an existing fixture, retain the screws for
use with the new fixture.
4. Raise fixture (D) to ceiling. Attach safety cable (F)
from the fixture (D) to the crossbar using hex nut
(H) and screw (G).
5. Using suitable wire connectors (not provided),
connect fixture wires to supply wires (white to white
or ribbed and black to black or smooth. Connect all
ground wires to green ground screw (B).
Caution: Make sure wire connectors are twisted on
securely, and no bare wire is exposed.
6. Slide fixture (D) over threaded studs and push firmly
to ceiling, making sure that no wires are pinched
between fixture and ceiling. Fasten with knurl balls
(E). Be sure studs (C) are fully seated in the knurl balls (E).
7. Refer to instructions on next page to install glass & bulbs.
8. Restore electricity at main breaker.
(continued)
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL
INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.
This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
(Figure 1)