Hubbardton Forge 124450 - Manual

Installation & Assembly Instructions
A130
Tryne Semi-Flush Chain Hung 12-4450 Page 1 of 3
Hand-Forged, Vermont-Made Lighting and Accessories
154 Route 30 South, Castleton, Vermont 05735 20803 Rev A
To Attach Stem Assembly (Figure 1)
Component Parts
A Stem Assembly
B Fixture Coupling
1. Carefully unpack the fixture from the carton.
2. Carefully thread stem assembly (A), threaded end first, over fixture wires.
3. Apply a drop of the supplied thread locking compound to the internal threads of fixture
coupling (B) and screw into fixture, being careful not to twist the wires.
Note: Application of the thread locking compound is necessary to prevent the stem from
loosening during regular maintenance and cleaning of the fixture. Be certain to apply the
compound.
4. See instructions below to complete the installation.
To Install the Canopy (Figure 2)
Component Parts
C Ground Screw
D Crossbar
E Lock Nut
F Nipple G Canopy
H Loop Collar
I
Canopy Loop
J Loop Assembly
Caution: Be sure power is off at the main breaker box prior to installation
1. Using two machine screws (not provided), fasten the crossbar (D) to the electric box
(see illustration).
Note: A new electric box comes with screws. When replacing a fixture, retain the
existing screws for use with the new fixture.
2. Thread the nipple (F) into the crossbar (D) and secure with lock nut (E); slide
canopy (G) over nipple (F), and attach the canopy loop (I) to the nipple (F). Adjust
the nipple to proper length to ensure a snug canopy fit before proceeding.
3. Attach one end of the chain to the loop assembly (J). Lace the wire through every
other link of the chain to the end. Slip wires and chain through the collars and
canopy (G, H & I). Fasten the chain to the canopy loop (I). Make sure to provide
enough slack in the wire to ensure weight of fixture is supported by the chain.
4. Using suitable wire connectors (not provided) connect fixture wires to supply wires
(white to ribbed side of the fixture s cord, black to smooth side). Run a pigtail lead
from crossbar ground screw (C) to the junction box and connect all ground wires (bare
copper or green to bare copper or green).
Caution: Make sure wire connectors are twisted on securely, and no bare wire is exposed.
5. Raise canopy (G) to the ceiling and secure loop collar (H) to canopy loop (I).
(continued)
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL
INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.
This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
(Figure 1)
(Figure 2)