Hubbardton Forge 124550 - Manual

Installation Instructions
A112
Compass Semi-Flush 12-4550 Page 1 of 2
Hand-Forged, Vermont-Made Lighting and Accessories
154 Route 30 South, Castleton, Vermont 05735
19836 Rev A
To Install Fixture (Figure 1)
Component Parts
A Crossbar
B Ground Screw
C Threaded Stud (2)
D Fixture
E Knurl Ball (2)
Caution: Be sure power is off at the main breaker box prior to installation
1. Remove tab (H) from glass frame (J) by removing flat
head screw (F). Do not discard tab or flat head screw.
2. Carefully unpack the fixture from the carton.
3. Thread studs (C) through appropriate holes in cross bar
(A) to match hole centers in fixture (D). Move ground
screw (B) to another available threaded hole if necessary.
4. Using two machine screws (not provided) fasten cross bar
(A) to the electric box using outer oval holes to orient
fixture to desired hanging position.
Note: A new electric box comes with screws. When
replacing an existing fixture, retain the screws for use with
the new fixture.
5. Using suitable wire connectors (not provided), connect
fixture wires to supply wires (white to white or ribbed and
black to black or smooth. Connect all ground wires to
green ground screw (B).
Caution: Make sure wire connectors are twisted on
securely, and no bare wire is exposed.
6. Slide fixture (D) over threaded studs and push firmly to
ceiling, making sure that no wires are pinched between
fixture and ceiling. Fasten with knurl balls (E). Be sure
studs (C) are fully seated in the knurl balls (E).
7. Refer to instructions on next page to install glass & bulbs.
8. Restore electricity at main breaker.
(continued)
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL
INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.
This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
(Figure 1)