Hubbardton Forge 124710 - Manual

Assembly & Installation Instructions
A208
For Antasia Semi-Flush 12-4710 & 12-4710E Page 1 of 2
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735 22811
Please Note: After installation extra hardware and accessories are possible due to our kits are used on multiple products
and options.
To Assemble Fixture (Figure 1)
Component Parts
A Fixed Arms (2)
B Loose Arm
C Glass
D Screw
1. Carefully unpack the fixture from the carton.
2. Loosen and remove screw (D) allowing loose arm (B) to be removed. Save for later use. Note: Arm is shipped
installed.
3. Slip glass (C) into two fixed arms (A).
4. Slip loose arm (B) up through hole in canopy and attach with screw (D) until snug.
(continued)
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL
INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.
This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
(Figure 1)