Hubbardton Forge 124905 - Manual

Assembly & Installation Instructions
A240
For Staccato Semi-Flush 12-4905 Page 1 of 2
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735 24423
To Prepare Fixture for Installation (Figure 1)
Component Parts
A Lower Assembly
C Fixture
Caution: Be sure power is off at the main breaker box prior to installation
1. Carefully unpack the fixture from the carton.
2. Unthread lower assembly (A) from fixture (C) by turning counter
clockwise.
3. Save all parts for later use.
To Install Fixture to Ceiling (Figure 2)
Component Parts
A Lower Assembly
B Canopy
C Fixture
D Ground
Screw
E Crossbar
Caution: Be sure power is off at the main breaker box prior to installation
1. Using two machine screws (not provided) fasten crossbar (E) to the
electric box.
Note: A new electric box comes with screws. When replacing an existing
fixture, retain the screws for use with the new fixture.
2. Using suitable wire connectors (not provided); connect fixture wires to
supply wires (white to white and black to black).
Caution: Make sure wire connectors are twisted on securely, and no bare
wire is exposed.
3. Lift canopy (B) and connect all ground wires to green ground screw (D).
4. Push canopy (B) firmly to ceiling, making sure that no wires are pinched
between fixture canopy and ceiling.
5. Thread lower assembly (A) onto fixture (C) until snug to canopy (B).
(continued)
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL
INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.
This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
(Figure 1)
(Figure 2)