Hubbardton Forge 126501 - Manual

H U B B A R D T O N F O R G E . C O M
hand-forged, vermont-made lighting and accessories
154 RT. 30 SOUTH • CASTLETON, VERMONT 05735
All designs and images ©1989-2013 Hubbardton Forge ® . All rights reserved. 19777 Rev A
Assembly & Installation Instructions
If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased this product.
We hope you enjoy your fixture!
* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.
To Install Fixture (Figure 1)
Component Parts
A Ground Screw
B Cross Bar
C Threaded Stud (3)
D Canopy
E Barrel Knobs (3)
CAUTION: BE SURE POWER IS OFF AT THE MAIN BREAKER BOX PRIOR
TO INSTALLATION.
1. Carefully unpack the fixture from the carton.
2. Thread studs (C) through appropriate holes in cross bar (B)
to match hole centers in canopy (D). Move ground screw (A)
to another available threaded hole if necessary.
3. Using two machine screws (not provided) fasten cross bar
(B) to the electric box using outer oval holes to orient fixture
to desired hanging position.
Important: A new electric box comes with screws. When replacing
an existing fixture, retain the screws for use with the new fixture.
4. Using suitable wire connectors (not provided); connect
fixture wires to supply wires (white to white and black to
black). Connect all ground wires to green ground screw (A).
CAUTION: MAKE SURE WIRE CONNECTORS ARE TWISTED ON
SECURELY, AND NO BARE WIRE IS EXPOSED.
5. Slide fixture canopy (D) over threaded studs and push firmly
to ceiling, making sure that no wires are pinched between
fixture canopy and ceiling. Fasten with barrel knobs (E). Be
sure studs (C) are fully seated in barrel knobs (E).
6. Restore electricity at main breaker.
A106
For Semi-Flush Models 126498 & 126501 Page 1 of 3
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL INJURY OR DEATH AND
PROPERTY DAMAGE. We recommend installation by a licensed electrician. This product must be installed in accordance with
applicable installation code(s), by a person familiar with the construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
A
B
C
(Figure 1)
(Continued)
E
D