Hubbardton Forge 126620 - Manual

Installation Instructions
A286
For Semi-Flush 12-6615 & 12-6620 Page 1 of 2
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735 26769
To Install Fixture (Figure 1)
Component Parts
A Canopy
B Cross
Bar
C Threaded Stud (2)
D Knurled Balls (2)
E Ground
Screw
Caution: Be sure power is off at the main breaker
box prior to installation
1. Thread studs (C) through appropriate holes in
cross bar (B) to match hole centers in canopy
(A). Move ground screw (E) to another
available threaded hole if necessary.
2. Using two machine screws (not provided)
fasten cross bar (B) to the electric box using
outer oval holes to orient fixture to desired
hanging position.
Note: A new electric box comes with screws.
When replacing an existing fixture, retain the
screws for use with the new fixture.
3. Using suitable wire connectors (not provided);
connect fixture wires to supply wires (white to
white and black to black). Run a pigtail lead
from crossbar ground screw (E) to the junction
box and connect all ground wires (Bare copper
or green to bare copper or green).
Caution: Make sure wire connectors are
twisted on securely, and no bare wire is
exposed.
4. Slide fixture canopy (A) over threaded studs
and push firmly to ceiling, making sure that no
wires are pinched between fixture canopy and
ceiling. Fasten with knurled balls (D). Be sure
studs (C) are fully seated in knurled balls (D).
(continued)
(Figure 1)
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL
INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.
This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
This illustration represents a typical
fixture and may not match every style.