Hubbardton Forge 126753 - Manual

Assembly & Installation Instructions
A139
For Impressions Semi-Flush 12-6750 & 12-6753 Page 1 of 2
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735 21145
To Install Fixture (Figure 1)
Component Parts
A Ground Screw
B Cross Bar
C Threaded Stud (3)
D Canopy
E
Barrel Knobs (3)
Caution: Be sure power is off at the main breaker box prior to installation
1. Carefully unpack the fixture from the carton.
2. Thread studs (C) through appropriate holes in cross bar (B) to match hole
centers in canopy (D). Move ground screw (A) to another available
threaded hole if necessary.
3. Using two machine screws (not provided) fasten cross bar (B) to the
electric box using outer oval holes to orient fixture to desired hanging
position.
Note: A new electric box comes with screws. When replacing an existing
fixture, retain the screws for use with the new fixture.
5. Using suitable wire connectors (not provided); connect fixture wires to supply wires (white to white and black to
black). Connect all ground wires to green ground screw (A).
Caution: Make sure wire connectors are twisted on securely, and no bare wire is exposed.
6. Slide fixture canopy (D) over threaded studs and push firmly to ceiling, making sure that no wires are pinched
between fixture canopy and ceiling. Fasten with barrel knobs (E). Be sure studs (C) are fully seated in barrel
knobs (E).
(continued)
(Figure 1)
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL
INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.
This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.