Hubbardton Forge 305615 - Manual

Installation Instructions
B168
For Outdoor Meridian Wall sconce 30-5615 & 30-5615F Page 1 of 2
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735 22611
For fixtures requiring assembly, please refer to assembly instructions before installation.
To Install Fixture (Figures 1, 2 & 3)
Component Parts
A Crossbar
B Threaded Studs (2)
C Fixture
D Barrel Knobs (2)
E Caulking
Lip
F 8-32 x 3/8” Screws (3)
G Retaining Ring (2) (“F” version
has only 1 retaining ring)
H Spider Assembly
I 8-32 x 1” Screws (3)
J Socket
Caution: Be sure power is off at the main breaker box prior to
installation.
1. Carefully unpack the fixture from the carton.
2. Remove glass retaining rings (G) and save for later use.
Note – “F” version has only one retaining ring.
3. Loosen screws (I) that are shipped installed in threaded bosses on
underside of fixture next to socket. Loosen screws (I) until there
are only a couple threads engaged with the threaded bosses.
4. Loosen screws (F) so that spider assembly (H) will turn clock wise.
It is not necessary to completely remove screws (F) from fixture.
Once spider assembly (H) is loose turn until it slips over the heads
of the screws. Set aside for later use (Figure 2).
5. Using two machine screws (not provided) attach cross bar (A) to
the electric box using inside oval holes to orient fixture. Note: A
new electric box comes with screws. When replacing a fixture,
retain the screws for use with the new fixture.
6. Start threaded studs (B) into appropriate holes in crossbar (A).
7. Using suitable wire connectors (not provided), connect the fixture
wires to the supply wires, (white to white, black to black, bare copper or
green to bare copper or green). If the fixture is wired with twin lead
lamp cord, connect the ribbed side to white, and the smooth side to
black.
Caution: Make sure wire connectors are twisted on securely and no
bare wires are exposed.
8. Apply a generous bead of a suitable caulking material to caulking lip (E)
on the fixture (Figure 3).
9. Carefully tuck all wires behind the fixture. Place fixture (C) over
threaded studs (B) and tighten firmly to mounting surface using barrel
knobs (D).
(continued)
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL
INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.
This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
(Figure 2)
(Figure 3)
(Figure 1)