Hubbardton Forge 305995 - Manual

H U B B A R D T O N F O R G E . C O M
hand-forged, vermont-made lighting and accessories
154 RT. 30 SOUTH • CASTLETON, VERMONT 05735
All designs and images ©1989-2013 Hubbardton Forge ® . All rights reserved. 22253 B
Installation Instructions
If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased this product.
We hope you enjoy your fixture!
* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.
To Install Fixture to Wall (Figure 1 & 2)
Component Parts
A Fixture
B Mounting Bracket
C Wall Anchor (4)
D 8-32 x 1” Screw (4)
E 8-32 Screw (2)
F Ground Screw
G Cupped Washer
H Caulking Lip
Note: Fixture enclosure to be located four feet above the ground.
Caution: Be sure power is off at the main breaker box prior to
installation.
Carefully unpack the fixture from the carton.
1. Carefully unpack the fixture from the carton.
2. Center the wall mount bracket (B) over the electrical box
being sure to hold it plum and level. With a pencil, mark the
location of all mounting holes in the wall mount bracket on
the wall behind.
IMPORTANT: Wall mount bracket must be secured to a solidly
mounted electrical box and/or a framing member in at least two
locations. Do not depend on drywall anchors alone to support this
fixture. If in doubt, contact a qualified electrician.
Put the wall mount bracket down and drill 1/4" holes in the
locations marked on the wall. For holes using anchors,
place the tapered end of the wall anchors (C) into the holes
and gently tap them flush to the wall using a light weight
hammer.
3. Using suitable wire connectors (not provided), connect the
fixture wires to the supply wires, (white to white or ribbed
and black to black or smooth, and bare copper or green
to bare copper or green). Ground the mounting bracket
using the green ground screw (F) and cupped washer (G) to
secure a pigtail lead to the bracket.
B158
For Outdoor Sconces 305995 & 305995F Page 1 of 2
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL INJURY OR DEATH AND
PROPERTY DAMAGE. We recommend installation by a licensed electrician. This product must be installed in accordance with
applicable installation code(s), by a person familiar with the construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
(Figure 1)
(Continued)
(Figure 2)
H
G
F
C
B
D
E
A