Hubbardton Forge 307287 - Manual

Installation Instructions
B8
For Direct Wire Wall Mounted Wet Location Fixtures - A
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL
INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.
This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
For fixtures requiring assembly, please refer to assembly instructions before installation.
Please Note: This fixture is designed to be mounted on a standard wall surface and may not be suitable for all
applications. If installing in a non-wood frame application, we recommend consulting a qualified builder or electrician.
Component Parts
A. Fixture
B. Screw Cap
C. Nipple D. Lock Nut
E. Cross Bar
F. Caulking Lip
To Install
Caution: Be sure power is off at the main breaker box prior to installation.
1. Carefully unpack the fixture from the carton.
2. Using two machine screws (not provided) attach cross bar (E) to the
electric box.
Note: A new electric box comes with screws. When replacing a fixture,
retain the screws for use with the new fixture.
4. Thread the nipple (C) into the crossbar and secure with lock nut (D).
Adjust the nipple to proper length to ensure the fixture will fit snugly to
the wall.
5. Using suitable wire connectors (not provided), connect the fixture wires
to the supply wires, (white to white, black to black, bare copper or green
to bare copper or green). If the fixture is wired with twin lead lamp cord,
connect the ribbed side to white, and the smooth side to black.
Caution: Make sure wire connectors are twisted on securely and no
bare wires are exposed.
6. Apply a generous bead of a suitable caulking material to caulking lip (F)
on the fixture.
7. Carefully tuck all wires behind the fixture, place fixture firmly against
the wall and fasten screw cap (B). To ensure a water tight seal, apply a
thin bead of caulking around entire perimeter of the fixture.
8. Install light bulb(s) (not provided), and glass.
9. Restore electricity at the main breaker.
These illustrations represent a typical
fixture and may not match every style.
If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased
this product. We hope you enjoy your fixture!
* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735 16057 RevA