Hubbardton Forge 307910 - Manual

Installation Instructions
B136
For Airis Sconce 30-7910 Page 1 of 3
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735 21155 Rev F
To Install Fixture (Figures 1 & 2)
Component Parts
A Crossbar
B 8-32 x 1” Screw
C Fixture
D 8-32 x 3/8” Screw (2)
E Mounting
Bracket
F #10 x 1” Screws (2)
G Caulking
Lip
H Screw
Caution: Be sure power is off at the main breaker box prior to installation.
1. Carefully unpack the fixture from the carton.
2. Using two machine screws (not provided) attach crossbar (A) to the
electric box. Note: A new electric box comes with screws. When
replacing a fixture, retain the screws for use with the new fixture.
3. From center hole of crossbar measure down 13-3/16" and mark location
for first hole for wall mounting bracket (E). Be sure hole location is
vertical to center hole of crossbar (A).
4. Hold mounting bracket (E) so hole matches location marked previously
and mark bottom hole location.
5. Attach mounting bracket (E) using #10 x 1" screws (F).
6. Loosen screws (D) so they do not protrude through edge of mounting bracket (E)
at this time. Note: Screws are shipped installed in bracket.
7. Install screw (H) in tab on bottom of fixture (C). Screw should only be installed a
couple of turns at this time (Figure 2).
8. Using suitable wire connectors (not provided), connect the fixture wires to the
supply wires, (white to white, white to black, bare copper or green to bare copper
or green).
Caution: Make sure wire connectors are twisted on securely and no bare wires
are exposed.
9. Apply a generous bead of a suitable caulking material to caulking lip (G) on the
fixture (Figure 2).
10. Carefully tuck all wires behind the fixture, align bottom of fixture with mounting
bracket (E), place fixture firmly against the wall and fasten with 8-32 x 1" screw
(B). To ensure a water tight seal, apply a thin bead of caulking around entire
perimeter of the fixture.
11. Tighten screw (D) on both sides of mounting bracket (E) until snug against fixture.
12. Install light bulb (not provided).
13. See installation instructions below for option purchased.
(continued)
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL
INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.
This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
(Figure 2)
(Figure 1)