Hubbardton Forge 307930 - Manual

Installation Instructions
B174
For Outdoor Wall Sconce 30-7930 Page 1 of 4
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735
22709 Rev A
To Install Fixture to Wall (Figures 1 & 2)
Component Parts
A Mounting Bracket
B Wood Screws (8)
C 3/8” Long Black Screws (2)
D Rubber
Washer (2)
E Fixture Assembly
F Ground Screw
G Cupped Washer
H Caulking Lip
O 3/4” Long Black Screws (2)
Caution: Be sure power is off at the main breaker box prior to installation.
1. Carefully unpack the fixture from the carton.
2. Center the wall mount bracket (A) over the electrical box being sure to hold
it plum and level. With a pencil, mark the location of all mounting holes in
the wall mount bracket on the wall behind. We've supplied wood screws
with your fixture; however, different materials and/or construction methods
may require different fasteners. If in doubt, contact a qualified electrician.
IMPORTANT: This fixture must be mounted or supported independently of
an outlet box.
3. Thread the wires in the electrical box through the center hole in the wall
mount bracket while moving the bracket into position. Using the wood screws (B),
screw the bracket securely to the wall.
4. Hold the fixture assembly (E) close to the wall mount bracket and using suitable wire
connectors (not provided), connect fixture wires to supply wires (white to white, black
to white, and bare copper or green to bare copper or green). Ground the mounting
bracket using the green ground screw (F) and cupped washer (G) to secure a pigtail
lead to the bracket.
Caution: Make sure wire connectors are twisted on securely and
no bare wires are exposed.
5. Apply a generous bead of a suitable caulking material to caulking lip (H) on fixture.
6. Carefully tuck all wires behind the fixture, place fixture firmly onto bracket (A) and
fasten with two 3/4” long black screws (C) and two rubber washers (D) on top. (Rubber
side of the washer goes against top of fixture)
7. Install two 3/8” long black screws (C) in bottom of fixture attaching to wall mounting
bracket (A).
8. Install light bulb (not provided).
9. Continue to diffuser option installation.
(continued)
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL
INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.
This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
(Figure 2)
(Figure 1)